CPR © 2021 FORD MOTOR COMPANY
DEARBORN, MICHIGAN 48121
12/2021
Page 10 of 22
1. Ensure the vehicle transmission gear selector is
in the PARK position. Check that the vehicle
READY light is off to verify the high voltage
system is disconnected. If the vehicle READY
light is on, press the engine Start/Stop button to
turn off the ignition.
PLACE COPY HERE
PLACE COPY HERE
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
2. Raise and position the LH front seat forward.
1101M
PLACE COPY HERE
PLACE COPY HERE
PLACE COPY HERE
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
PLACE COPY HERE
PLACE COPY HERE
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
3. Release the retainers and remove the LH
front seat rear trim panel.
4. Position the LH front seat backrest cover and
release a retainer (1). Position the LH front seat
backrest cover (2).
PLACE COPY HERE
PLACE COPY HERE
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
STUD FOR
MISSING NUT
NOTE: Perform as many of these steps as able to ensure the high voltage system is disabled.