9. CAUTION: The valve cover sealing surfaces are soft materials. Do not use abrasive grinding discs to remove gasket material. Use only a plastic scraping tool. Do
not scratch or gouge sealing surfaces or oil leaks can occur.
Clean and inspect the sealing surfaces of the valve cover and cylinder head. Both surfaces must be clean and flat.
10. Remove the catalytic converter. For additional information, refer to Section 309-00.
11. Remove the bolt and nut and position the coolant tube aside.
12. Remove the wheel and tire assembly. For additional information, refer to Section 204-04.
13. Remove the RH lower splash shield.
14. Rotate the crankshaft to just before top dead center (TDC) (No. 1 cylinder).
15. Remove the stud.
16. Install the special tool.
2002 Escape Workshop Manual
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2K/~MUS~LEN/20/S
To Next Page
Loading...
