17. NOTE: Make sure the correct (second) notch in the pulley is indexed to the lower cylinder block.
Rotate the crankshaft clockwise against the peg to bring it to TDC (No. 1 cylinder).
18. Loosen the coolant pump pulley bolts.
19. Loosen the crankshaft pulley bolt.
20. Rotate the tensioner and remove the accessory drive belt.
21. Remove the bolt and the crankshaft pulley.
2002 Escape Workshop Manual
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2K/~MUS~LEN/20/S
To Next Page
Loading...
