7. Sand and prime the flange area and apply a continuous bead of seam sealer to the entire door hem flange
perimeter.
8. Prime and paint the door flange area using a Ford-approved paint system.
9. Apply rust inhibitor to the inside of the door assembly to all hem flange and upper belt line areas. For
additional information, refer to Restoring Corrosion Protection Following Repair
in this section.
10. Install the door on the vehicle. For additional information, refer to Section 501-03 and refinish using a Ford-
approved paint system.
11. Install the stationary window glass bracket.
12. Install the door latch, outer door handle and lock cylinder. For additional information, refer to Section 501-
14 .
13. Install the window glass. For additional information, refer to Section 501-11 .
14. Install the side view mirror. For additional information, refer to Section 501-09 .
15. Install weatherstripping and mouldings.
To Next Page
Loading...
