Black plate (124,1)
Windscreen Wipers and
Washer
The ignition switch must be in the ON
position.
NOTE
Because something heavy can jam the
wiper blades, the wiper motor is
protected from motor breakdown,
overheating and possible fire by a
circuit breaker. This mechanism will
automatically stop operation of the
blades, but only for about 5 minutes.
If this happens, turn off the wiper
switch and park off the right-of-way,
and remove the object.
After 5 minutes, turn on the switch and
the blades should operate normally. If
they don't resume functioning, consult
an expert repairer, we recommend an
Authorised Ford Repairer as soon as
possible. Drive to the side of the road
and park off the right-of-way. Wait until
the weather clears before trying to drive
with the wipers inoperative.
qWindscreen Wipers
Turn the wipers on by pulling the lever
down.
― Mist
INT ― Intermittent
1 ― Low speed
2 ― High speed
For a single wiping cycle, push the lever
up to
.
Variable-speed intermittent wipers
Set the lever to INT an d choose the
interval timing by rotating the ring.
INT ring
5-40
Driving Your Ford
Switches and Controls
EVEREST_F8K4-10-06H_Edition1 Page124
Friday, August 11 2006 10:37 AM
Form No.F8K4-10-06H
To Next Page
Loading...
Need help?
General
