Once speed control is switched off,
the previously programmed set
speed will be erased.
To set a speed
Press SET ACC. For speed control
to operate, the speed control must
be ON and the vehicle speed must
be greater than 48 km/h (30 mph).
If you drive up or down a steep
hill, your vehicle speed may vary
momentarily slower or faster than
the set speed. This is normal.
Speed control cannot reduce the
vehicle speed if it increases above
the set speed on a downhill. If
your vehicle speed is faster than
the set speed while driving on a
downhill in Overdrive, you may
want to shift to the next lower
gear to reduce your vehicle speed.
If your vehicle slows down more
than 16 km/h (10 mph) below your
set speed on an uphill, your cruise
control will disengage. This is
normal. Pressing RSM will
re-engage it.
Do not use the speed
control in heavy traffic or
on roads that are winding,
slippery, or unpaved.
RSM
SET
ACC
COAST
uno_setting-a-speed
uno_tap-up-feature
Controls and features
41
To Next Page
Loading...
