Resuming a set speed
Press the RES/RSM (resume)
control and release it. This will
automatically return the vehicle to
the previously set speed. The
RES/RSM control will not work if
the vehicle speed is not faster than
48 km/h (30 mph).
Increasing speed while using speed control
There are two ways to set a higher
speed:
• Press and hold the SET ACCEL
control until you get to the
desired speed, then release the
control. You can also use the SET
ACCEL control to operate the
Tap-Up function. Press and
release this control to increase the vehicle set speed in small amounts
by 1.6 km/h (1 mph).
• Use the accelerator pedal to get to the desired speed. When the
vehicle reaches that speed press and release the SET ACCEL control.
Reducing speed while using speed control
There are two ways to reduce a set
speed:
• Press and hold the COAST
control until you get to the
desired speed, then release the
control. You can also use the
COAST control to operate the
Tap-Down function. Press and
release this control to decrease the vehicle set speed in small amounts
by 1.6 km/h (1 mph).
R
E
S
S
E
T
A
C
C
E
L
COAST
RSM
SET
ACCEL
COAST
R
E
S
S
E
T
A
C
C
E
L
COAST
RSM
SET
ACCEL
COAST
RSM
SET
ACCEL
COAST
R
E
S
S
E
T
A
C
C
E
L
COAST
2003 F150 (f12)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
64
https://www.MyCarManual.com
To Next Page
Loading...
