Displaying the Factory-Set Code with Integrated Keyhead
Transmitters
Note: You will need to have two programmed Integrated Keyhead
Transmitters for this procedure.
To display the factory-set code in the information display:
1. Place the first programmed key in the ignition.
2. Turn the ignition off and remove the first programmed key.
3. Place the second programmed key in the ignition.
You will see the factory-set code in the message center. The code
appears for a few seconds.
Note: The code may not display until after any other warning messages
first display.
Locks 85
2014 Flex (471)
Owners Guide gf, 2nd Printing, November 2013
USA (fus)
To Next Page
Loading...
