1312
THIRDROW SEAT*
To Fold and Stow the Third-Row Seat
Note: Make sure that the area under the seat is free of objects
before stowing it.
1. Remove all objects from the seat and floor stowage tub area.
2. From the rear of the vehicle, fold the head restraint by pulling the
head restraint release strap.
3. Fold the seatback by pulling and holding the red strap while pushing
the seatback forward. Release the strap once the seatback starts
rotating forward.
4) To fold the seat fully into the floor, release the seat latches by pulling
and holding the short black strap and then pulling the headrest
release strap. This tumbles the seat all the way into the floor tub.
COMFORT
FLEX
COMFORT
To Unstow the Third-Row Seat
Note: Make sure that the forward portion of the load floor is free
of objects before unstowing the seat.
1. Unlatch and lift the seat out of the tub in the floor by squeezing and
pulling up on the handle. When the seat is in a vertical position, push
the seat over, letting it fall onto the latches.
2. To return the seatback to the upright position, pull the red strap.
Then, while holding the red strap, pull the long strap located on the
seatback to raise the seatback.
3. Pull the head restraints up to their normal positions.
Note: Push and pull on the seat to make sure it latches to the
vehicle floor. An unlatched seat may become dangerous in
the event of a sudden stop or crash.
POWERFOLD
®
THIRDROW SEAT*
Note: The powerfold seats work only when the transmission is in
park (P) and the liftgate is open.
The third-row seat features a power one-touch operation that allows you
to adjust the seats with the touch of a button. The buttons are behind the
third-row seats on the left-side, quarter-trim panel.
To use, press the RH/BOTH/LH button to select the right seat, both
seats or the left seat that you want to move.
Then select the desired seat position:
• Press the STOW button to stow the seat
into the tub floor.
• Press the FOLD button (the top portion of
the button) to fold down the seatback.
• Press the NORMAL button to return the
seat to the normal seating position.
POWER LIFTGATE*
Your liftgate has an automatic open and close feature. To open remotely,
press twice on your remote within three seconds. Press twice
again to stop the movement. You can also operate the liftgate by pressing
the button on the instrument panel.
*IF EQUIPPED