Engine
1. CAUTION: Do not use abrasive grinding discs to remove the gasket material; use only plastic manual scrapers. Do not scratch or gouge aluminium sealing
surfaces.
NOTE: All bearing surfaces must be lubricated before assembly or installation.
NOTE: The crankshaft main bearings are precision selective fit. For additional information, refer to Section 303-00.
Install the main bearings.
1. Upper crankshaft main bearing.
2. Crankshaft thrust main bearing.
2. Install the crankshaft.
3. NOTE: The crankshaft main bearings are numbered 1 to 5 with No. 1 at the front of the engine. Make sure the arrow faces the front of the engine.
NOTE: Apply axial load to the rear of the crankshaft simultaneously to tightening of the bolts. For additional information, refer to Section 303-00.
Install the five lower crankshaft main bearings and the five main bearing caps.
4. Install the piston and connection rod assemblies.
SECTION 303-01B: Engine — 2.0L SPI 2002 Focus Workshop Manual
ASSEMBLY
Procedure revision date: 12/14/2000
Special Tool(s)
Crankshaft Rear Seal Pilot
303-329 (T88P-6701-B2)
Crankshaft Rear Seal Replacer
303-328 (T88P-6701-B1)
Oil Pump Seal Replacer
303-164 (T81P-6700-A)
Strap Wrench
303-D055 (D85L-6000-A) or equivalent
Material
Engine oil WSS-M2C153-H
Silicone gasket and
sealant
F6AZ-19562-AA or equivalent Ford specification WSE-
M4G323-A6
Page 1 of 92002 Focus Workshop Manual
6/19/2008htt
://www.fordtechservice.dealerconnection.com/
ubs/content/~WS2Y/~MUS~LEN/20/S
...
To Next Page
Need help?
General
