5. Install the four crankshaft rod caps.
6. NOTE: Coat the rear oil seal area and the crankshaft rear oil seal lip with engine oil.
NOTE: Make sure the crankshaft rear oil seal is on correctly and that the edges are not rolled over.
Using the special tools, install a new crankshaft rear oil seal.
7. Install the crankshaft rear seal retainer.
z Use a new gasket.
8. Install the oil pump.
z Use a new gasket.
9. Using the special tool, install a new oil pump seal.
10. Install the oil baffle.
Page 2 of 92002 Focus Workshop Manual
6/19/2008htt
://www.fordtechservice.dealerconnection.com/
ubs/content/~WS2Y/~MUS~LEN/20/S
...
To Next Page
Loading...
