Ford Ka - Page 32

15
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
Setting the clock (Hour)
This function is used to set the clock.
To perform the adjustment proceed
as follows:
– briefly press button MENU
ESC,
“hours” will flash on the display;
– press the button + or − for setting;
– briefly press button MENU ESC,
“minutes” will flash on the display;
– press the button + or − for setting;
– briefly press button MENU
ESC
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
Adjusting the beeper volume
(Buzz)
This function is used to adjust
the volume of the buzzer triggering
in the event of failure/warning
indications and when MENU
ESC
+ and − buttons are pressed.
To set the desired volume, proceed
as follows:
– briefly press button MENU ESC, the
display will show the wording (bUZZ);
– press + or − to select the required
volume (adjustable over 8 levels).
– briefly press button MENU
ESC
to go back to the menu screen or
press the button for long to go back
to the standard screen without storing
settings.
Speed limit setting (Speed)
With this function, it is possible to
set the car speed limit (km/h or mph).
When this limit is exceeded, the driver
is immediately alerted (see section
“Warning lights and messages”).
To set the desired speed limit, proceed
as follows:
– briefly press button MENU
ESC,
the message (SPEEd) and the previously
set unit (km/h) or (mph) will be displayed;
– press + or − to activate (On)
or deactivate (OFF) the speed limit;
– when the function is activated (On)
pressing buttons + or − select the
speed limit and press MENU
ESC
to confirm selection.
Note Selection is possible between
30 and 200 km/h, or 20 and 125 mph
depending on the selected unit, see
paragraph “Unit of measure”.
The setting will increase/decrease
by five units each time +/− is pressed.
Hold the button +/− pressed to
increase/decrease the setting rapidly
and automatically. Complete the setting
by briefly pressing the button when you
approach the required value.
– briefly press button MENU
ESC
to go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
To cancel the setting, proceed
as follows:
– briefly press button MENU ESC:
(On) will flash on the display;
– press the button −, “Off” flashes
on the display;
– briefly press button MENU ESC
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
001-025 Ford KA EN:001-025 Ford KA IT 14-10-2010 11:20 Pagina 15