Ford Ka - Page 36

19
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
KNOWING
YOUR CAR
– briefly press button MENU ESC
to go back to the menu screen or press
the button for long to go back to the
standard screen without storing settings.
To cancel the setting, proceed as follows:
– briefly press button MENU ESC:
(On) will flash on the display;
– press the button −, “Off” flashes
on the display;
– briefly press button MENU ESC
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
Trip B data (Trip B enablement)
This function can be used to activate
(On) or deactivate (Off) the Trip
B display (partial trip).
For further information see “Trip
computer”.
Proceed as follows to switch
the function on and off:
– briefly press button MENU
ESC :
(On) or (Off) will flash on the display
(according to previous setting);
– press the button + or − to select;
– briefly press button MENU ESC
to go back to the menu screen or press
the button for long to go back to
the standard screen without storing
settings.
Speed Beep (Speed limit)
This function is used to set the car
speed limit (km/h or mph); the driver
is immediately alerted when this limit
is exceeded (see chapter “Warning
lights and messages”).
To set the desired speed limit, proceed
as follows:
– briefly press button MENU
ESC,
the display will show the message
(Speed Buzz);
– press button + or − to select speed
limit activation (On) or deactivation
(Off);
– if the function has been activated (On),
press buttons + or − to select
the required speed limit and then
press MENU
ESC to confirm.
Note. The speed may be set in the range
from 30 to 200 km/h, or from 20 to
125 mph according to the previously
chosen unit (see “Setting the distance
unit” paragraph ) described below.
The setting will increase/decrease by five
units each time the button +/ − is pressed.
Hold the button +/ − pressed to increase/
decrease the setting rapidly
and automatically. Complete the setting
by single pressing the button when
you approach the required value.
Setting the time (Clock)
This function enables the clock to
be set through two submenus: “Time”
and “Format”.
To carry out the adjustment, proceed
as follows:
– briefly press button MENU ESC,
the display will show the two sub-
menus “Time” and “Mode”;
– press the button + or − to switch
between the two submenus;
– select the required option and then
briefly press button MENU
ESC;
– if selecting “Time”, briefly press button
MENU ESC, “hours” will flash on the
display;
– press the button + or − for setting;
– briefly press button MENU ESC,
“minutes” will flash on the display;
– press the button + or − for setting;
001-025 Ford KA EN:001-025 Ford KA IT 14-10-2010 11:20 Pagina 19