5
Emergency Starter Interrupt Disarm Procedure
If your remote control transmitter is lost or fails to function, use this procedure to start
your vehicle.
1. Use the keys to enter the vehicle.
2. Insert the key into the ignition and turn to the ON position.
3. Locate and press the programming/override button mounted under the instrument
panel.
System Maintenance
Changing the Remote Control Battery:
The 12-volt alkaline battery supplied in your remote control should
last approximately one year, depending on usage. When the
battery begins to weaken, you will notice a decrease in range, or
the distance from your vehicle that your remote transmitter will
operate. Follow the instructions below to change the remote
transmitter battery.
1. Insert the edge of a coin into the slot at the top of the remote
control. Twist the coin to pry the remote control halves apart.
2. Remove the old battery and replace with a new one. Be sure to
observe the (+) and (-) signs in the battery compartment.
3. Carefully snap the case halves back together, then test the
remote control.
It is not necessary to re-program the remote control after
changing the battery.
Adding Remote Controls to Your System:
The system has the ability to operate from up to eight (8) remote controls. Follow these
instructions to add a remote control to your system.
1. Make sure the security system is disarmed and the ignition is off.
2. Open the driver’s door.
3. Turn vehicle ignition on.
4. Press and hold programming/override button under the instrument panel.
After 15 seconds, the horn will chirp three (3) times. This indicates that the unit has
entered the remote control programming mode.
5. Release the programming/override button.
6. Press the button on the remote control to be programmed.
The siren or horn will sound once, indicating that the system has “learned” that
remote control.
7. Repeat step 6 for any additional remote controls.
8. Turn the vehicle ignition off to exit the programming mode. Test all remote controls to
ensure that they work properly.
Deleting Lost or Stolen Remote Control Transmitters from Your System:
Lost or stolen PowerCode remote control transmitters can be easily deleted by
reprogramming all eight transmitter code locations. Follow the steps above and program
any combination of transmitters a total of eight times.
To Next Page
Loading...
Need help?
General
