In addition to the standard installation tools, you will be required to have a have a Hand Crimping Tool (Greenlee brand
shown below or comparable), an Inch Pound Torque Screwdriver and a 6mm Tapping Tool.
Before you begin your install make sure when unpackaging the unit that all equipment is on hand and has not been
damage. Once you have determined that all hardware is present follow the preinstall steps.
Remove the screws from the L1, Ground and L2 terminals, see illustration below. Remove the flat washer and locking
washer and insert screw into the terminals and screw down manually to check that the threads of the equipment and
the bolt are free and clear of any obstructions. Note: never use a corded rill to install these screws.
Once it is determined that the screws are free from obstruction mount charger for wiring.
To Next Page
Loading...
