Ford Probe - Page 124

124
*
[AS02600(ALL)04/95]
❑
Using the “SCAN/TUNE” button to scan
radio stations
*
[AS02700(ALL)04/95]
Pressing the “SCAN/TUNE” button once
enters the scan mode (display will indicate
“SCN”). Pushing the top
a
half of the
“SEEK” button will begin the scan mode up
the frequency band, stopping on each
listenable station for approximately five
seconds. Pushing the bottom
b
half of the
“SEEK” button will begin the scan mode
down the frequency band, again stopping on
each listenable station for approximately five
seconds.
*
[AS02800(ALL)04/95]
To stop the scan mode on the presently
sampled station press the “SCAN/TUNE”
button again.
*
[AS03000(ALL)04/95]
❑
Setting the Station Memory Preset buttons
%
*
[AS03100(ALL)04/95]
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
FM stations (5 in FM1 and 5 in FM2). Follow
the easy steps below to set these buttons to
the desired frequencies.
*
[AS03200(ALL)04/95]
1. Select a band, then select a frequency.
*
[AS03400(ALL)04/95]
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
*
[AS03500(ALL)04/95]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS03601(ALL)04/95]
NOTE: If the vehicle’s battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995