130
*
[AS08350(ALL)05/95]
Pressing and holding the bottom (
b
) or top (
a
)
half of the “SEEK” button will scroll backward
and forward respectively through the tracks.
*
[AS08400(ALL)05/95]
How to fast forward or reverse your CD
player
*
[AS08500(ALL)05/95]
To quickly search for a particular point in a
selection, press the “FF” button (to fast forward)
or the “REV” button (to reverse). While either
button is pressed, the disc goes forward or
backward at two different speeds depending on
how long the button is held down. (Pressing
either button for more than approximately three
seconds will speed up the process.) Release the
button at the desired point (found by watching
the elapsed playing time in the display or by
listening to the sound during fast forward or
reverse). When you have reached the beginning
of track 1, the CD player will begin playing.
*
[AS08600(ALL)04/95]
When you have reached the end of the disc by
keeping the fast forward button pressed, the
display will show “END” and the player will go
into pause mode. Push the “PLAY/STOP”
button to begin playing the first track of the
disc, press the “REV” button to back up from
the end of the disc, or use the “SEEK” function
to locate a desired track.
*
[AS08700(ALL)04/95]
Using the “SCAN” function
[AS08800(ALL)05/94]
Press the “SCAN/TUNE” button to enter the
scan mode. Once in the scan mode, press the top
(
b
) or bottom (
a
) half of the “SEEK” button to
scan forward or reverse, respectively. The CD
player will begin scanning the disc, stopping on
each listenable track for approximately an
eight-second sampling. This continues until you
press the “SCAN/TUNE” button a second time.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995
To Next Page
Loading...
