Ford Probe - Page 224

227
[SV21450(ALL)05/95]
Refilling the engine coolant — 2.0L engine
*
[SV21500(ALL)03/95]
When the entire engine cooling system is to be
drained and refilled, use the following
procedure:
*
[SV21600(ALL)01/89]
1. Remove the radiator cap.
*
[SV21700(ALL)06/89]
2. With the engine off and cool, add a 50/50
mixture of recommended engine cooling
system fluid and water until the radiator is
full.
*
[SV21800(ALL)07/93]
3. Replace and fully tighten the radiator cap,
then unscrew the cap to the first stop.
*
[SV21900(ALL)06/89]
4. Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and engine coolant is
flowing through the entire system).
[SV22000(ALL)04/95]
5. Shut the engine off and check the fluid level
in the radiator. Add more fluid if necessary.
[SV22005(ALL)03/94]
6. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
[SV22010(ALL)01/92]
Refilling the engine coolant — 2.5L engine
[SV22015(ALL)04/95]
When the entire cooling system is to be drained
and refilled, use the following procedure:
[SV22020(ALL)04/93]
1. Locate the radiator breather cap and the
coolant system cap in your engine
compartment. The cap on your right
(driver’s side) is the radiator breather cap.
The cap on your left (passenger’s side) is the
coolant system cap.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995