Ford Probe - Page 262

265
*
[SV48860(ALL)06/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[SV48870(ALL)06/95]
1. Start the engine. Drive or idle (in neutral)
the vehicle for 4 minutes.
[SV48880(ALL)05/95]
2. Idle the vehicle in drive (neutral for
automatic transaxles) for 40 seconds.
[SV48890(ALL)05/95]
3. Accelerate the vehicle to 45 mph (72 km/h)
(for manual transaxles upshift from 1st to
5th gear, but hold in 2nd for at least 5
seconds) at 1/4 to 1/2 throttle for 10
seconds.
[SV48895(ALL)05/95]
4. Drive the vehicle with a steady throttle at
45 mph (72 km/h) (manual transaxles use
5th gear) for 30 seconds.
[SV48900(ALL)05/95]
5. Idle the vehicle in drive (neutral for manual
transaxles) for 40 seconds.
[SV48910(ALL)05/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-64 km/h) (manual transaxles primarily
drive vehicles in 3rd and 4th gear when
possible) for 15 minutes. During the 15
minute drive cycle the following modes must
be achieved:
*
[SV48920(ALL)06/95]
a. at least 5 stop and idle modes at 10
seconds each
*
[SV48930(ALL)06/95]
b. acceleration from idles at 1/4 to 1/2
throttle position, and
*
[SV48940(ALL)06/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
[SV48950(ALL)05/95]
7. Accelerate the vehicle up to between 45 and
60 mph (72-97 km/h) (manual transaxles
upshift to 5th gear). This should take
approximately 5 minutes.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995