Ford Ranger 1998 - Page 11

18. NOTE: Inspect and install new O-rings as necessary.
Remove the protective caps and connect the fuel lines to the fuel rail and install the safety clips.
19. NOTE: Tighten the bolts in sequence and in two steps.
Install the upper intake manifold and gasket.
1. Tighten to 20 Nm (14 lb-ft).
2. Tighten to 25 Nm (18 lb-ft).
20. Connect the power brake booster vacuum hose.
21. Connect the positive crankcase ventilation (PCV) valve hose.
22. Connect the vacuum hose at the EGR valve (9D475).
23. Connect the vacuum hose at the heater control.
16
1998 Ranger Workshop Manual
11/21/2009
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWL/~MUS~LEN/21
...