Ford Taurus 2002 - Support Brackets and Catalytic Converter Nuts

20. Remove the lower cowl assembly.
 Remove the three screws.
 Remove the clip.
21. Remove the rear support brace.
1. Remove the bolt.
2. Remove the nut.
3. Remove the rear support brace.
22. Install the rear engine lifting bracket in the same location where the top bolt was removed from the rear support brace.
23. Install the 3 Bar Engine Support.
24. NOTE: It may be easier to access the nuts for the exhaust flange from the engine compartment.
Remove the front nuts from the front catalytic converter assembly.
10
2002 Taurus/Sable Workshop Manual
12/26/2010
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2H/~MUS~LEN/20/
...