32. CAUTION: If the steering gear is removed with the subframe, do not allow the steering wheel to rotate while the steering column intermediate is disconnected or
damage to the clockspring can result. If there is evidence that the shaft has rotated, the clockspring must be recentered before the vehicle is driven. For additional
information, refer to Section 501-20B.
Remove the sub frame assembly. For additional information, refer to Section 502-00.
33. NOTE: The use of mechanic's wire will aid in positioning the halfshaft out of the way.
Using the special tools, remove the LH halfshaft from the transaxle and position out of the way.
34. NOTE: The use of mechanic's wire will aid in positioning the halfshaft out of the way.
Using the special tools, remove the RH halfshaft from the transaxle and position out of the way.
35. Remove the nut and the battery ground cable.
36. Remove the starter motor. For additional information, refer to Section 303-06.
37. Remove the cooler line retaining clips.
38. Depress the tabs on the plastic insert retainer and remove the cooler lines from the fitting.
2002 Taurus/Sable Workshop Manual
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2H/~MUS~LEN/20/
To Next Page
Loading...
