138
[CF43300(ALL)01/96] 5. The keyless system registers this second code. To open your
vehicle, you can now use either code. The module
remembers only one personal code at a time. Entering a
second personal code will erase the first and replace it with
the new code.
[CF43400(ALL)01/96] 6. After you have entered your personal code, the driver’s door
will unlock.
*
[CF43500(ALL)05/96]
To erase your personal code:
*
[CF43600(ALL)05/96] 1. Enter the original permanent code.
[CF43700(ALL)01/96] 2. Press the 1/2 button within five seconds of step #1.
*
[CF43800(ALL)05/96] 3. Wait six seconds.
[CF43900(ALL)01/96] 4. The keyless entry system automatically erases your personal
code. The system will now only respond to the permanent
code.
*
[CF44000(ALL)05/96]
Do not set a code that presents the numbers in sequential order,
such as 1/2, 3/4, 5/6, 7/8, 9/0. Studies show that people who
idly press the buttons usually press a sequential pattern. Also,
do not select a code that uses the same button five times.
Thieves can easily figure out these types of codes.
% [CF44100(ALL)04/96]
Unlocking the Doors with the Keyless Entry System
[CF44200(ALL)01/96]
You must unlock the driver’s door before you unlock any of the
other doors. If you let more than five seconds pass between
pressing numbers, the system shuts down and you have to
enter the code again. The system has shut down if the keypad
light is out. If the keyless entry system does not work properly,
use the key or Remote Entry transmitter(s) to lock and unlock
the doors or liftgate until the system can be serviced.
[CF44300(ALL)01/96] 1. To unlock the driver’s door, enter the code. All codes have 5
numbers. After you press the fifth number, the driver’s door
unlocks.
File:05wncfs.ex
Update:Wed Jul 31 15:55:37 1996
To Next Page