Controls and Features
145
%
*
[CF50800(ALL)07/96]
Arming the System
*
[CF50900(ALL)01/96] 1. Remove the key from the ignition. The hood must be closed
to arm the system.
*
[CF51000(ALL)05/96] 2. Open any door. The alarm indicator light will start flashing
to remind you to arm the system.
[CF51100(ALL)04/96] 3. Lock the doors by using the power door lock switch. The
alarm indicator light will now glow steadily.
[CF51200(ALL)01/96] 4. Close all doors. The alarm indicator light will then remain
on steadily for 30 seconds and then go out. When the light
goes out, the system is armed.
*
[CF51300(ALL)01/96]
NOTE: Be sure to close all doors completely. If not, the alarm
indicator light will remain on. Remember, your
anti-theft system is armed only after the alarm
indicator light remains on steadily for approximately
30 seconds after the last door is closed, and then goes
out.
*
[CF51400(ALL)01/96]
You can also arm the anti-theft system with the factory installed
remote entry system or the keyless entry system by following
this sequence:
*
[CF51500(ALL)01/96] 1. Remove the key from the ignition. The hood must be closed
to arm the system.
*
[CF51600(ALL)01/96] 2. Close all of the doors.
[CF51700(ALL)01/96] 3. Press the remote entry transmitter LOCK button or use the
keyless entry system by pressing 7/8 and 9/0 at the same
time. The alarm indicator will come on for 30 seconds to
show the alarm is arming and then turn off to show that it
has armed.
[CF51800(ALL)01/96]
The anti-theft system is designed to work with the factory
installed remote keyless entry system. It may not work with
other remote entry systems.
File:05wncfs.ex
Update:Wed Jul 31 15:55:37 1996
To Next Page
Loading...
