Electronic Sound Systems
73
*
[AS23160(ALL)02/96]
■ Using the “SCAN” function (Stereo Cassette Radio)
*
[AS23170(ALL)06/95]
Press the “SCAN” button to enter the scan mode. The radio
will begin scanning up the frequency band, stopping on each
listenable station for approximately a five-second sampling.
This continues until you press the “SCAN” button a second
time. The display flashes “AM” or “FM.”
*
[AS23200(ALL)03/96]
■ Setting the station MEMORY PRESET buttons
*
[AS23325(ALL)02/96]
Your radio is equipped with 5 station memory buttons.
These buttons can be used to select up to 5 preset AM
stations and 10 preset FM stations (5 in FM1 and 5 in FM2).
*
[AS23400(ALL)08/95]
Follow the easy steps below to set these buttons to the desired
frequencies:
*
[AS23500(ALL)06/96] 1. Select a band, then select a frequency.
*
[AS23700(ALL)06/96] 2. Press one of the memory preset buttons and hold the button
until the sound returns. That station is now held in memory
on that button.
*
[AS23800(ALL)06/96] 3. Follow the two steps above for each station memory preset
button you want to set.
*
[AS23900(ALL)03/96]
NOTE: If the vehicle’s battery is disconnected, the clock and
station memory preset buttons will need to be reset.
*
[AS24000(ALL)10/95]
Adjusting the tone balance and speaker output of your
radio
*
[AS24100(ALL)02/96]
■ Increasing or decreasing bass response
*
[AS24225(ALL)02/96]
Push the “AUDIO” button repeatedly until the display reads
“BASS.” Push the right (+) side of the “VOLUME” button to
increase bass (more “lows”), and push the left (s) side to
decrease bass (less “lows”).
File:04wnass.ex
Update:Mon Jul 8 14:13:42 1996
To Next Page
Loading...
