INSTALLATION PROCEDURE / STEP 5
- 5 -
5
Run a thin bead of silicone caulk down the entire length of both bottom ledges on the bottom track.
Place the bottom track into position and press down firmly along the length of the track.
INSTALLATION PROCEDURE / STEP 6 / STEP 7
6
Push wall plugs into holes drilled in Step 3 and tap them in with a rubber mallet.
NOTE: If you are installing on fiberglass or acrylic, skip this step and discard the wall plugs.
7
Dab silicone into all 3 holes on each side. Run 1 1/2" pan head screws through wall bumper and use
to attach wall jamb to wall in top and bottom holes only on both sides.
1 1/2" PAN HEAD SCREW
To Next Page
Loading...