711 Ogden Ave. Lisle, IL, 60532, USA
tel# 1-630-964-8000, WWW.LOCKFORMER.COM
Ver. US-03-2005
Page 2
TO CHANGE FLANGE HEIGHT
The shims are set at the factory to run a flange of ¼” (6mm). This dimension can be
changed in the following manner. Remove the 4 Hex. Hd cap screws on the plate and
change the desired dimension. The adjustable shim will give a range of ¼” (6mm) to 7/8”
(22mm). This procedure can be done on the left and right plates if desired.
PARTS FOR 24” double sided CHEEK BENDER
• Pictures are not to scale!
•
Handle # 4R151 Grip # 5T667
#
2G208 Bottom Plate
Trunion Plate # 3D310
# 25095 Pivot Bar Right
#250965 Pivot Bar Left
To Next Page
Loading...