FORMTEK Lockformer CHEEK BENDER

To Next Page

711 Ogden Ave. Lisle, IL, 60532, USA

tel# 1-630-964-8000, WWW.LOCKFORMER.COM

Ver. US-03-2005

Page 1

CHEEK BENDER

Double sided 24” Model

Instructions

MOUNTING UNIT

Place the cheek bender on

work table so that sufficient

clearance is available for

bending the maximum size

section. Make sure that the

unit is placed so the open end

over hangs the table. When

the unit is in the most desired

work position, fasten it to a

work table or bench.

Place handles into the pivot

bar holes and lock them into

place with Allen head screws.

OPERATION

Place the edge to be formed into the slot and move the handle to make a bend.

Need help?

Do you have a question about the FORMTEK Lockformer CHEEK BENDER and is the answer not in the manual?

Summary

Instructions

Mounting Unit

Place the cheek bender on work table, ensure clearance, and fasten to a table or bench.

Operation

Place the edge to be formed into the slot and move the handle to make a bend.

To Change Flange Height

Parts for 24 Double Sided Cheek Bender

Shims

Top Plate

Pivot Bar Leaf

Pivot Hinge

Pivot Bar