- Remove then the syringe from the
connector.
- Reassemble the grub screw and
the O-ring paying the latter special
attention.
Remark:
To invert the brake controls
procede as follows:
-Detach connector A (fig 13)
from its pump and invert both
hoses. Reassemble by
proceeding as in 2.3.
Fig. 13
3.0 MAINTENANCE
WARNING: read the safety rules
Periodically clean the caliper in relation
to the bike use, the route length, and
the weather conditions using a
biodegradable degreaser suitable for
the caliper.
Carefully clean all moving parts.
CAUTION:
ISOPROPYL ALCOHOL is
recommended to clean the disc
brake. The use of any other
product may be hazardous to
the user.
CAUTION: Do not touch the
rotor right after its use as it
might cause you severe injury.
3.1 Changing the brake
fluid
Periodically, in relation to the bike
use it is necessary to entirely
change the system’s brake fluid.
This operation must be carried
out only by personnel authorized
by Formula.
To Next Page
Loading...
