Required tools
▪ Torque wrench with 3 mm tool.
▪ Allen key 3 mm
▪ Torx T10 key
▪ Formula mineral oil
Upgrade CURA E-Bike
Procedure
Remove the oil inside the brake system using the bleeding screw on the master cylinder and on the caliper, using a
Torx T10 key. Dispose the oil correctly.
1. Remove the bleeding screw in the middle bleeding hole (6) on the master cylinder with a Torx T10 key.
2. Place the O-Ring (1) in its seat on the bleeding screw included in the kit (2). Tight the knob (3) until the end of its
stroke.
To Next Page
Loading...
