5. Place the magnet (5) in its seat on the piston(11) without removing it from its seat. Place back the lever, inserting
the seeger and the dust seal back. To put the dust seal back use a not sharpened tool, in order to not damage the
dust seal itself. Tight the lever pivot using a torque wrench with 3 mm tool (3 Nm) and a 3 mm allen key.
6. Place the reed sensor (4) unitl it fits well.
7. Bleed the brake with Formula mineral oil. For the correct procedure, follows the video on Formula’s YouTube
Channel: Bleeding CURA.
To Next Page
Loading...
