Fortinet 548B - Page 142

- 142 -
7.2.16.7 fip-snooping vlan
This command enables FIP snooping on a VLAN. VLAN must be configured before it can be used. Once
VLAN is enabled, the FIP packets will be snooped only on the configured VLANs. FIP snooping is
disabled on VLANs by default.
Syntax
fip-snooping vlan <vlan id>
no fip-snooping vlan <vlan id>
<1 - 3965> - VLAN ID.
no - This command disable snooping on a specific VLAN.
Default Setting
Disabled
Command Mode
Global Config
7.2.17 Enhanced Transmission Selection (ETS)
7.2.17.1 show queue ets
This command displays ETS mode on specific interface.
Syntax
show queue ets <slot/port>
<slot/port> - Interface number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Name of the interface.
Mode: ETS mode.