Fortinet 548B - Page 156

- 156 -
Interface-Vlan Config
7.3.1.8 ip filter
This command is used to enable the IP filter function.
Syntax
ip filter
no ip filter
no – Disable ip filter.
Default Setting
Disabled
Command Mode
Global Config
This command is used to set an IP address to be a filter.
Syntax
ip filter <ipaddr>
no ip filter <ipaddr>
<ipaddr> - Configure a IP address to the filter.
no - Remove this IP address from filter.
Default Setting
None
Command Mode
Global Config
7.3.2 Serial Interface Commands
7.3.2.1 show line console
This command displays serial communication settings for the switch.