Fortinet 548B - Page 177

- 177 -
virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all |
lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all |
packets | virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change |
neighbor-state-change | virtif-statechange | virtneighbor-state-change}}
no snmp-server enable traps ospfv3 {all | errors {all | authentication-failure | bad-packet | config-error |
virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all |
lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all |
packets | virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change |
neighbor-state-change | virtif-statechange | virtneighbor-state-change}}
no - This command disables OSPFv3 trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables PIM traps.
Syntax
snmp-server enable traps pim
no snmp-server enable traps pim
no - This command disables PIM trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables the sending of new root traps and topology change notification traps.
Syntax
snmp-server enable traps stpmode
no snmp-server enable traps stpmode
no - This command disables the sending of new root traps and topology change notification traps.
Default Setting