Fortinet 548B - Page 184

- 184 -
ip http secure-port <portid>
no ip http secure-port
<portid> - SSLT Port value.
no - This command is used to reset the SSLT port to the default value.
Default Setting
443
Command Mode
Global Config
7.3.7.6 ip http secure-server
This command is used to enable the secure socket layer for secure HTTP.
Syntax
ip http secure-server
no ip http secure-server
no - This command is used to disable the secure socket layer for secure HTTP.
Default Setting
Disabled
Command Mode
Global Config
7.3.7.7 ip http secure-protocol
This command is used to set protocol levels (versions). The protocol level can be set to TLS1, SSL3 or
to both TLS1 and SSL3.
Syntax
ip http secure-protocol <protocollevel1> [protocollevel2]
no ip http secure-protocol <protocollevel1> [protocollevel2]
<protocollevel1 - 2> - The protocol level can be set to TLS1, SSL3 or to both TLS1 and SSL3.
no - This command is used to remove protocol levels (versions) for secure HTTP.