Fortinet 548B - Page 186

- 186 -
no - This command is used to disable SSH.
Default Setting
Disabled
Command Mode
Global Config
7.3.8.3 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2),
or both SSH 1 and SSH 2 (1 and 2) can be set.
Syntax
ip ssh protocol <protocollevel1> [protocollevel2]
<protocollevel1 - 2> - The protocol level can be set to SSH1, SSH2 or to both SSH 1 and SSH 2.
Default Setting
SSH1 and SSH2
Command Mode
Global Config
7.3.8.4 ip ssh maxsessions
This command specifies the maximum number of SSH connection sessions that can be established. A
value of 0 indicates that no ssh connection can be established. The range is 0 to 5.
Syntax
ip ssh maxsessions <0-5>
no ip ssh maxsessions
<0-5> - maximum number of sessions.
no - This command sets the maximum number of SSH connection sessions that can be established
to the default value.
Default Setting
SSH1 and SSH2
Command Mode
Global Config