Fortinet 548B - Page 190

- 190 -
Default Setting
None
Command Mode
Global Config
7.3.11.3 serviceport protocol
This command specifies the oob configuration protocol to be used. If you modify this value, the change is
effective immediately.
Syntax
serviceport protocol {bootp | dhcp | dhcp6 | none [dhcp6]}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IP address by setting configuration.
<none dhcp6> - Obtains IPv6 address by setting configuration.
Default Setting
None
Command Mode
Global Config
7.3.11.4 serviceport protocol dhcp6 restart
This command is used to initiate a DHCPv6 client request by oob interface.
Syntax
serviceport protocol dhcp6 restart
Default Setting
None
Command Mode
Global Config