Fortinet 548B - Page 196

- 196 -
Default Setting
6343
Command Mode
Global Config
7.3.13.10 set sflow interval
The user can go to the CLI Interface Configuration Mode to set polling interval, use the sflow poller
interval <0-86400> interface configuration command. Use the no sflow poller interval return to default
value zero.
Syntax
sflow poller interval <0-86400>
no sflow poller interval
Default Setting
0
Command Mode
Interface Config
7.3.13.11 set sflow sampler index
The user can go to the CLI Interface Configuration Mode to configure a new sFlow sampler instance, use
the sflow sampler <index> interface configuration command. Use the no sflow sampler return to
default setting.
Syntax
sflow sampler <index>
no sflow sampler
Default Setting
None
Command Mode
Interface Config