Fortinet 548B - Page 209

- 209 -
no - This command sets the spanning-tree operational mode to be disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
Default Setting
Disabled
Command Mode
Global Config
7.4.2.2 spanning-tree protocol-migration
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
Syntax
spanning-tree protocol-migration {<slot/port> | all}
no spanning-tree protocol-migration {<slot/port> | all}
<slot/port> - is the desired interface number.
all - All interfaces.
no - This command disables BPDU migration check on a given interface. The all option disables
BPDU migration check on all interfaces.
Default Setting
None
Command Mode
Global Config
7.4.2.3 spanning-tree configuration
This command sets the Configuration Identifier Name for use in identifying the configuration that this
switch is currently using. The <name> is a string of at most 32 alphanumeric characters.
Syntax
spanning-tree configuration name <name>
no spanning-tree configuration name
<name> - is a string of at most 32 alphanumeric characters.
no - This command resets the Configuration Identifier Name to its default.