- 277 -
Syntax
sntp unicast client poll-timeout <poll-timeout>
no sntp unicast client poll-timeout
< poll-timeout > - Polling timeout in seconds. The range is 1 to 30.
no - This command will reset the poll timeout for SNTP unicast clients to its default value.
Default Setting
The default value is 5.
Command Mode
Global Config
7.10.2.6 sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients in seconds.
Syntax
sntp unicast client poll-retry <poll-retry>
no sntp unicast client poll-retry
< poll-retry> - Polling retry in seconds. The range is 0 to 10.
no - This command will reset the poll retry for SNTP unicast clients to its default value.
Default Setting
The default value is 1.
Command Mode
Global Config
7.10.2.7 sntp server
This command configures an SNTP server (with a maximum of three) where the server address can be
an ip address or a domain name and the address type either IPv4, IPv6, dnsv6 or dns. The optional
priority can be a value of 1-3, the version is a value of 1-4, and the port id is a value of 1-65535.
Syntax
sntp server <ipaddress/ipv6address/domain-name> <addresstype> [<1-3> [<version> [<portid>]]]
no sntp server remove <ipaddress/ipv6address/domain-name>
To Next Page