- 290 -
Inventory Specifies if inventory TLV is present in LLDP frames.
Hardware Rev: Specifies hardware version.
Firmware Rev: Specifies Firmware version.
Software Rev: Specifies Software version.
Serial Num: Specifies serial number.
Mfg Name: Specifies manufacturers name.
Model Name: Specifies model name.
Asset ID: Specifies asset id.
Location Specifies if location TLV is present in LLDP frames.
Subtype: Specifies type of location information.
Info: Specifies the location information as a string for given type of location id.
Extended POE Specifies if local device is a PoE device.
Device Type: Specifies power device type.
Extended POE PSE Specifies if extended PSE TLV is present in LLDP frame.
Available: Specifies available power sourcing equipment's power value in tenths of watts on the
port of local device.
Source: Specifies power source of this port.
Priority: Specifies PSE port power priority.
Extended POE PD Specifies if extended PD TLV is present in LLDP frame.
Required: Specifies required power device power value in tenths of watts on the port of local
device.
Source: Specifies power source of this port.
Priority: Specifies PD port power priority.
7.12.1.11 show lldp med remote-device
The user can go to the CLI Privilege Exec to d display the summary information about remote devices
that transmit current LLDP-MED data to the system. use the show lldp med remote-device
{<slot/port> | all} Privilege command.
Syntax
show lldp med remote-device {<slot/port> | all}
Default Setting
None
To Next Page