- 292 -
Vlan ID: Specifies the VLAN id associated with a particular policy type.
Priority: Specifies the priority associated with a particular policy type.
DSCP: Specifies the DSCP associated with a particular policy type.
Unknown: Specifies the unknown bit associated with a particular policy type.
Tagged: Specifies the tagged bit associated with a particular policy type.
Inventory Specifies if inventory TLV is received in LLDP frames on this port.
Hardware Rev: Specifies hardware version of the remote device.
Firmware Rev: Specifies Firmware version of the remote device.
Software Rev: Specifies Software version of the remote device.
Serial Num: Specifies serial number of the remote device.
Mfg Name: Specifies manufacturers name of the remote device.
Model Name: Specifies model name of the remote device.
Asset ID: Specifies asset id of the remote device.
Location Specifies if location TLV is received in LLDP frames on this port.
Subtype: Specifies type of location information.
Info: Specifies the location information as a string for given type of location id.
Extended POE Specifies if remote device is a PoE device.
Device Type: Specifies remote device's PoE device type connected to this port.
Extended POE PSE Specifies if extended PSE TLV is received in LLDP frame on this port.
Available: Specifies the remote ports PSE power value in tenths of watts.
Source: Specifies the remote ports PSE power source.
Priority: Specifies the remote ports PSE power priority.
Extended POE PD Specifies if extended PD TLV is received in LLDP frame on this port.
Required: Specifies the remote port's PD power requirement.
Source: Specifies the remote port's PD power source.
Priority: Specifies the remote port's PD power priority.
7.12.2 Configuration Commands
7.12.2.1 lldp notification
This command uses to enable remote data change notifications.
To Next Page