Fortinet 548B - Page 297

- 297 -
Interface Config
7.12.2.10 lldp med confignotification
The user can go to the CLI Interface Configuration Mode to set all the ports to send the topology change
notification, use the lldp med confignotification Interface configuration command. Use the no lldp
med confignotification to disable notifications.
Syntax
lldp med confignotification
no lldp med confignotification
Default Setting
Disabled
Command Mode
Interface Config
7.12.2.11 lldp med transmit-tlv
The user can go to the CLI Interface Configuration Mode to set Type Length Values (TLVs) in the LLDP
MED, use the lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location][network-policy] Interface configuration command. Use the no lldp med transmit-tlv
[capabilities] [ex-pd] [ex-pse] [inventory] [location][network-policy] to remove the TLVs.
Syntax
lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory] [location]
[network-policy]
no lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory] [location]
[network-policy]
capabilities -Transmit the LLDP capabilities TLV.
ex-pd - Transmit the LLDP extended PD TLV.
ex-pse - Transmit the LLDP extended PSE TLV.
inventory - Transmit the LLDP inventory TLV.
location - Transmit the LLDP location TLV.
network-policy - Transmit the LLDP network policy TLV.
Default Setting
None