Fortinet 548B - Page 315

- 315 -
Default Setting
Disabled
Command Mode
Interface Config
7.15 Protected Ports Commands
7.15.1 Show Commands
7.15.1.1 show switchport protected
This command displays the status of all the interfaces, including protected and unprotected interfaces.
Syntax
show switchport protected {all|<0-2>}
Default Setting
None
Command Mode
Privileged Exec
Display Message
Name: An name of the protected port group.
Member Ports: List of ports, which are configured as protected for the group identified with
<groupid>. If no port is configured as protected for this group, this field is blank.
7.15.1.2 show interface switchport protected
This command displays the status of the interface (protected/unprotected) under the groupid.
Syntax
show interface switchport protected <slot/port> <groupid>
Default Setting