Fortinet 548B - Page 354

- 354 -
Default Setting
None
Command Mode
Privileged Exec
Display Message
Source MAC Validation: Displays whether Source MAC Validation of ARP frame is enabled or
disabled.
Destination MAC Validation: Displays whether Destination MAC Validation is enabled or disabled.
IP Address Validation: Displays whether IP Address Validation is enabled or disabled.
VLAN: The VLAN ID for each displayed row.
Configuration: Displays whether DAI is enabled or disabled on the VLAN.
Log Invalid: Displays whether logging of invalid ARP packets is enabled on the VLAN.
ACL Name: The ARP ACL Name, if configured on the VLAN.
Static Flag: If the ARP ACL is configured static on the VLAN.
7.20.1.3 show ip arp inspection interfaces
This command displays the Dynamic ARP Inspection configuration on all the DAI-enabled interfaces. An
interface is said to be enabled for DAI if at least one VLAN, that the interface is a member of, is enabled
for DAI. Given a slot/port interface argument, the command displays the values for that interface whether
the interface is enabled for DAI or not.
Syntax
show ip arp inspection interfaces [slot/port]
<slot/port> - Interface Number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: The interface ID for each displayed row.
Trust State: Whether the interface is trusted or untrusted for DAI.
Rate Limit: The configured rate limit value in packets per second.
Burst Interval: The configured burst interval value in seconds.