Fortinet 548B - Page 356

- 356 -
no - This command disables Dynamic ARP Inspection on a list of comma-separated VLAN ranges.
Default Setting
Disabled
Command Mode
Global Config
7.20.2.3 ip arp inspection vlan logging
This command enables logging of invalid ARP packets on a list of comma-separated VLAN ranges.
Syntax
ip arp inspection vlan <vlan-list> logging
no ip arp inspection vlan <vlan-list> logging
no - This command disables logging of invalid ARP packets on a list of comma-separated VLAN
ranges.
Default Setting
Disabled
Command Mode
Global Config
7.20.2.4 ip arp inspection filter
This command configures the ARP ACL used to filter invalid ARP packets on a list of comma-separated
VLAN ranges. If the static keyword is given, packets that do not match a permit statement are dropped
without consulting the DHCP snooping bindings.
Syntax
ip arp inspection filter <acl-name> vlan <vlan-list> [static]
no ip arp inspection filter <acl-name> vlan <vlan-list> [static]
no - This command unconfigures the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Default Setting
No ARP ACL is configured on a VLAN