- 386 -
Non-Conform Action: The current setting for the action taken on a packet considered to not
conform to the policing parameters. This is not displayed if policing not in use for the class under this
policy.
Non-Conform DSCP Value: This field displays the DSCP mark value if this action is markdscp.
Non-Conform IP Precedence Value: This field displays the IP Precedence mark value if this action
is markprec.
Assign Queue: Directs traffic stream to the specified QoS queue. This allows a traffic classifier to
specify which one of the supported hardware queues are used for handling packets belonging to the
class.
Drop: Drop a packet upon arrival. This is useful for emulating access control list operation using
DiffServ, especially when DiffServ and ACL cannot co-exist on the same interface.
Mirror: Copies a classified traffic stream to a specified egress port (physical port or LAG). This can
occur in addition to any marking or policing action. It may also be specified along with a QoS queue
assignment.
Redirect: Forces a classified traffic stream to a specified egress port (physical port or LAG). This
can occur in addition to any marking or policing action. It may also be specified along with a QoS
queue assignment.
Policy Name: The name of this policy. (Note that the order in which the policies are displayed is not
necessarily the same order in which they were created.)
Policy Type: The policy type, namely whether it is an inbound or outbound policy definition.
Class Members: List of all class names associated with this policy.
7.21.5.6 show policy-map interface
This command displays policy-oriented statistics information for the specified interface and direction.
Syntax
show policy-map interface <slot/port> in
<slot/port> - specifies a valid slot number and port number for the system. The direction parameter
indicates the interface direction of interest.
Command Mode
Privileged Exec
Display Message
Interface: The slot number and port number of the interface (slot/port).
Direction: The traffic direction of this interface service, either in or out.
Operational Status: The current operational status of this DiffServ service interface.
Policy Name: The name of the policy attached to the interface in the indicated
direction.
To Next Page