Fortinet 548B - Page 400

- 400 -
Default Setting
None
Command Mode
Global Config
Interface Config
7.24 CoS (Class of Service) Command
7.24.1 Show Commands
7.24.1.1 show queue cos-map
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Syntax
show queue cos-map <slot/port>
< slot/port > - The interface number.
Default Setting
None
Command Mode
Privileged EXEC
User EXEC
Display Message
The following information is repeated for each user priority.
User Priority: The 802.1p user priority value.
Traffic Class: The traffic class internal queue identifier to which the user priority value is mapped.