- 402 -
Non-IP Traffic Class: The traffic class used for non-IP traffic. This is only displayed when the COS
trust mode is set to either 'trust ip-dscp' or 'trust ip-precedence'.
Untrusted Traffic Class: The traffic class used for all untrusted traffic. This is only displayed when
the COS trust mode is set to 'untrusted'.
7.24.1.4 show queue cos-queue
This command displays the class-of-service queue configuration for the specified interface. The slot/port
parameter is optional and is only valid on platforms that support independent per-port class of service
mappings. If specified, the class-of-service queue configuration of the interface is displayed. If omitted,
the most recent global configuration settings are displayed.
Syntax
show queue cos-queue <slot/port>
< slot/port > The interface number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: This displays the slot/port of the interface. If displaying the global configuration, this output
line is replaced with a Global Config indication.
Interface Shaping Rate: The maximum transmission bandwidth limit for the interface as a whole. It
is independent of any per-queue maximum bandwidth value(s) in effect for the interface. This is a
configured value.
The following information is repeated for each queue on the interface.
Queue Id: An interface supports n queues numbered 0 to (n-1). The specific n value is platform
dependent.
Minimum Bandwidth: The minimum transmission bandwidth guarantee for the queue, expressed
as a percentage. A value of 0 means bandwidth is not guaranteed and the queue operates using
best-effort. This is a configured value.
Scheduler Type: Indicates whether this queue is scheduled for transmission using a strict priority or
a weighted scheme. This is a configured value.
Queue Mgmt Type: The queue depth management technique used for this queue, either tail drop or
weighted random early discard (WRED). This is a configured value.
To Next Page