- 434 -
Syntax
show ip ospf abr
Default Setting
None
Command Mode
Privileged Eexc
User Exec
Display Messages
Type: The type of the route to the destination. It can be either:
• intra — Intra-area route
• inter — Inter-area route
Router ID: Router ID of the destination.
Cost: Cost of using this route.
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination.
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
8.3.1.3 show ip ospf area
This command displays information about the area. The <areaid> identifies the OSPF area that is being
displayed.
Syntax
show ip ospf area <areaid>
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
AreaID: The area id of the requested OSPF area.
External Routing: A number representing the external routing capabilities for this area.
Spf Runs: The number of times that the intra-area route table has been calculated using this area's
link-state database.
To Next Page